The act of showing the actual building, room, or object reduced in proportion from full-size to a smaller size is called correct answer: Scaling the
... [Show More] drawing
The instrument used to draw and measure scaled drawings is a correct answer: Architects scale
To establish the limits of a measurement on the drawing use correct answer: Extension lines
To check for certain practices that must be used in installing and testing a plumbing system, a plumber refers to the________ correct answer: Specifications
Compared to the requirements specified in applicable codes, it is acceptable for the plans and specifications for a particular building to call for an installation that is of_______ correct answer: Higher quality
The location of the sewer and water mains and the location of the building on the property is shown on the______ correct answer: Plot plan
Plot plans usually show _______ correct answer: Utility easements
To identify where floor drains and DWV pipes may be installed beneath the basement floor, refer to the _______ correct answer: Foundation plan
The layout of the rooms in a building is shown on the _______ correct answer: Floor plan
To ensure that there are no conflicts with the furnace and air conditioning equipment, refer to the _______ correct answer: HVAC/mechanical drawing
A representation of an object that gives the impression of three dimensions resembling the physical object is called _______ correct answer: Isometric
Vertical and horizontal piping along with sizes and a riser number that refers back to the full set of plumbing drawings are shown on correct answer: Riser diagrams
If an object is depicted from one or more of six possible angles, the illustration is a _______ correct answer: Orthographic drawing
To determine whether a certain fixture will fit in the available space, plumbers often use _______ correct answer: Fixture drawings
Drawings of products that provide enough detail to show how the product is constructed are called _______ correct answer: Cutaway drawings
_______ are lines with arrows or slashes at a termination line used to indicate the dimension of a distance on a drawing correct answer: Dimension lines
the _______ is the minimum distance that must be maintained between a structure and the structures property line, such as a Street correct answer: Setback
In _______ also called _______ The line represents the centerline of the pipe, so these drawings can be used to represent pipe of any diameter correct answer: Schematic, single line [Show Less]