Capacitor correct answers An electronic component that regulates the coils
Coil correct answers Create the impedance or resistance used to properly
... [Show More] regulate the machines speed and power
Contact screw correct answers Connects with the front spring/armature bar and the settings of this part with the distance between the armature bar and coils longer or shorter. Contact screw is the stationary contact point for the front spring.
Front Spring correct answers Part that is constantly in contact with the contact screw
Back spring correct answers Attached to the frame, front spring and armature bar, provides up and down motion of the needles.
Rear binding post correct answers Fixes the coils to the clip cord power from the power supplies.
Top Hat Gromment correct answers Part that helps needle to become steady on the armature bar
tube clamp correct answers For tubes and tips. Can be too small for some tubes and needs replaced after repeated use.
yoke correct answers Regulates the height of the coils
Armature bar (A-bar) correct answers The steel mass for the magnetic pull
Rotary tattoo machine correct answers Contains small motor encased in the tattoo machine itself which moves the attached needles up and down consistently without a break in the circuit.
Skin scribes correct answers A special marker pen used for drawing on skin freehand.
Thermafax paper correct answers Used to create stencils that are to be applied to the skin prior to tattooing.
Clip cord sleeves/machine bags, white bottle bags correct answers A thin plastic barrier that goes over a clip cord in the form of a sleeve.
foot switch correct answers Turns power supply on or off, allowing the artist to control the tattoo machine with their foot.
Clip cord correct answers Cable used to connect a tattoo machine to the tattoo machines power supply.
Tattoo needle basic overview correct answers Diameter, needles taper, amount of needles soldered to the needle bar, configuration of the needles soldered to the bar. [Show Less]