Engine vacuum is being discussed. Technician A says that when the engine is operating under light loads, engine vacuum is low. Technician B says that
... [Show More] engine vacuum is high when the engine is operated under heavy loads. Who is correct? correct answers d.
neither A nor B
Ignition spark typically occurs a few degrees _______. correct answers a. before top dead center (BTDC)
Which of the following is NOT an advantage of an electronic spark control system? correct answers b. It allows lower compression ratio engines to be as efficient as higher compression ratio engines
Air/fuel ratios are being discussed. Technician A says that when the air fuel ratio is higher than 14.7 to 1 the engine produces more power. Technician B says that when the air fuel ratio is lower than 14.7 to 1 the engine uses less fuel. Who is correct? correct answers d. neither A nor B
The first decision the computer makes in determining the best operating strategy is to determine the _____. correct answers b. engine operating mode
Catalytic converter monitors are being discussed. Technician A says that if the converter is working, the downstream signal frequency should mirror the upstream sensor. Technician B says that the downstream sensor should provide a low-frequency voltage signal. Who is correct? correct answers b. B only
What sensor is used to detect engine misfire? correct answers a. crankshaft position
Oxygen sensor monitors are being discussed. Technician A says the system monitors the sensor response time as the system cycles lean-rich-lean. Technician B says that at certain times the monitor varies the fuel delivery and checks for heated oxygen sensor response. Who is correct? correct answers c. both A and B
EGR monitors are being discussed. Technician A says some EGR system monitors EGR flow by measuring the difference in pressure as the EGR gas flows through an orifice (restriction). Technician B says some EGR monitors measure the temperature of the EGR outlet to determine whether there is gas flowing through the EGR valve. Who is correct? correct answers c. both A and B
Freeze frame data is being discussed. Technician A says erasing the code with a scan tool will erase the corresponding freeze frame data. Technician B says the freeze frame data is the sensor and output status data at the instant the DTC was set. Who is correct? correct answers c. both A and B [Show Less]