STSC Exam Study Guide 2024 Complete
Verified
STSC - CORRECT ANSWER-Safety Trained Supervisor in Construction
OHSMS - CORRECT
... [Show More] ANSWER-Occupational Health and Safety Management Systems
Management Leadership - CORRECT ANSWER-Establish clear safety and health
objectives for the OHSMS and operationally define the actions needed to achieve those
objectives
When in use, electrical power tools and cords must: - CORRECT ANSWER-Make use
of ground fault circuit interrupters or be a part of an assured grounding conductor
program
If a supervisor is given authority by the general manager to stop operations site
whenever he or she observes an imminent danger situation. The following correctly
identifies that authority... - CORRECT ANSWER-Functional authority
A certified Safety Trained Supervisor is expected to... - CORRECT ANSWER-seek
methods to improve your knowledge and understanding of methods, techniques and
practices for protection of workers. STS Code of ethics
Arrange the following hazard control steps in the most appropriate sequence: (1) guard
hazard, (2) engineer out hazard, if possible, (3) educate personnel - CORRECT
ANSWER-2-engineer out the hazard if possible, 1-guard hazard, 3-educate personnel
Which action is preferred when dealing with minor infractions of work safety rules? Oral
reprimand, Written reprimand, No response or consequence, suspension - CORRECT
ANSWER-Oral reprimand
System safety analysis can be applied to... - CORRECT ANSWER-Any system that has
interacting components
What should a supervisor do when a crew must walk across an area with open floor
holes to go to their work area? - CORRECT ANSWER-Have the floor holes covered and
inform crew of load surface restrictions
The strongest motivator, according to contemporary motivation theory is... - CORRECT
ANSWER-Recognition of achievement for performance
Management has increased work hours and is punishing for more productivity. As STS,
you are concerned about some of the safety risks associated with this production
schedule. You should... - CORRECT ANSWER-Inform/communicate increased hazards
due to increased production and verify that risk is acceptable
The best evaluation of tasks descriptor involving steps, hazards and solutions is... -
CORRECT ANSWER-Job Safety Analysis (JSA)
What minimum PPE is required for a worker in a grinding operation... - CORRECT
ANSWER-Eye and face protection
Minimally,_______authorized attendant(s) shall be on duty outside of the space during
permit required confined space operations and shall be responsible for securing
immediate aid, keeping an accurate count of entrants in case of emergency. -
CORRECT ANSWER-One
A medical questionnaire required when safety workers place an employee in respiratory
protection must be evaluated by whom? - CORRECT ANSWER-A licensed health care
professional aka (PLHCP) physician or other licensed health care professional
In construction, each employee on a walking/working surface (horizontal and vertical
surface) with an unprotected side or edge which is _______feet or more above a lower
level shall be protected from falling by the use of guardrail systems, safety net systems
or personal fall arrest systmes - CORRECT ANSWER-6 feet
A crew member deliberately violates a safety procedure. What should be done? -
CORRECT ANSWER-Stop work, write formal complaint and explain
Each employee on a scaffold more than_____feet above a lower level shall be provided
with fall protection to prevent from falling to a lower level - COR [Show Less]