NEIEP 500 Final exam latest update A+ graded
What is the name of the code that is the accepted standard for all electrical wiring
... [Show More] in the United States? - ans
What is the maximum distance between supports of a vertical raceway, based on NEC Article 620-32? - ans
What type of flex would be used to pipe a switch in a wet location? - ans
What is the name for the complete metal system of duct, conduit and flex that protects the wiring? - ans
How is the work divided when planning piping and wiring of an elevator installation? - ans
What document may be the only place to look for such information as type of fixtures, car panel, fire service floor, etc? - ans
What information is shown on a pull sheet? - ans
Which type of diagram shows a simplified path from positive to negative for all components in a circuit? - ans
How are multiple installations of traveling cables numbered for a single car? - ans
What is shown on the final layout? - ans
In the circuit shown, which is the common wired for the second level? -
How are wire sizes larger than 4/0 measured? - ans
What is the abbreviated term for current carry8ing capacity? - ans
What is the minimum size wired for lighting circuits in an elevator installation? - ans
What is the special about wire used for the interlock circuit? - ans
What is the smallest wire that is permitted in an elevator installation? - ans
When bending conduit, what is the maximum number of decrees of bend allowed between access points? - ans
What is the reference point on the thin-wall bender for the finish line of a back to back bend? - ans
What is the total in degrees of the bends in a three-bend saddle? - ans
You have 10' length of ¾" rigid conduit which needs to have a 90 degree bend with a 16" stub height. With a 7" take- up, what is the distance from the end of the pipe to the mark where the hickey arrow is aligned? - ans
......................................................continued..................................................... [Show Less]