What are 4 types of Steel Decking? - Composite, Roof, Cellular, and Form
What are the lengths of Full sheets of Steel Decking? - 12", 18", 24", 30", or
... [Show More] 36".
All are usually less than 40"
Who has full responsibility for Safety on a construction site? - The prime
contractor
Who is responsible to ensure workers have appropriate eye protection? - The
employer
Safety belt lanyard shall be a minimum of? - 1/2 inch nylon, w/ max length to
provide for a fall of no greater than 6ft. The rope shall have a nominal breaking
strength of 5,400 lbs.
When should safety nets be provided? - When workplaces are more than 25 feet
above ground or water surface or where use of ladders, scaffolds, catch platforms,
temporary floors, safety lines, or safety belts are impractical
What are the different types of Safety Equipment? - Head, Eye and Face, and
Respiratory protection. Safety belts, lifelines, lanyards, and safety nets
Where should quantities of flammable liquid in excess of 25 gallons be stored in
that is acceptable or approved? - Acceptable wooden storage and Approved metal
storage cabinets. Cabinets shall be labeled in conspicuous lettering "FlammableKeep Away from Open Flames"
LP-Gas storage outside of buildings for containers waiting use shall be located
from the nearest building or group of buildings in accordance to? - 1. 500 lbs or
less - 0ft
2. ***501 to 6,000 lbs - 10ft
3. 6,001 to 10,000 lbs - 20ft
4. Over 10,000 lbs - 25ft
Clearance and mounting of temporary heating devices are? - 1. Room heater,
circulating type - 12" sides, 12" rear, 18" chimney connector2. ***Room heater, radiant type - 36" sides, 36" rear, 18" chimney connector
How far shall heaters used in the vicinity of the combustible tarpaulins, canvas, or
similar coverings be located from the coverings? - 10 feet from coverings
Material stored inside buildings under construction shall not be placed with what
distances? - 6 feet of any hoistway or inside floor openings, ***not within 10 feet
of exterior wall which does not extend above the top of the material stored
Bagged materials shall be stacked by stepping back the layers and cross-keying the
bags at least by how many bags high? - 10 bags high
Brick stacks shall not be more than? - 7 feet in height
When a loose brick stack reaches a height of 4 feet, it shall be tapered back by how
many inches? - 2 inches in every foot of height above the 4-foot level
When masonry blocks are stacked higher than 6 feet, the stack shall be tapered
back how far? - Back one-half block per Tier above the 6-foot level
Used lumber shall have what withdrawn before stacking? - Nails
How shall lumber be stacked? - On level and solid supported sills, and stable and
self supporting
Lumber piles shall not Exceed? - 20 feet in height provided that lumber to be
handled manually shall not be stacked more than 16 feet high
Wire rope shall not be used if? - In any length of eight diameters, the total number
of visible broken wires exceeds 10 percent of the total number of wires, or if rope
shows other signs of excessive wear, corrosion, or defect
Waste materials - when materials are dropped more than 20 feet to any point lying
outside the exterior walls of the building what is needed? - An enclosed chute of
wood, or equivalent material, shall be used. Enclosed chute is a slide, closed in on
all sides, through which material is moved from a high place to a lower one
All other hand-held powered tools such as circular saws, chain saws, and
percussion tools without positive accessory holding means, shall be equipped withwhat? - A constant pressure switch that will shut off the power when the pressure
is released
Compressed air shall not be used for cleaning purposes except when? - Where
reduced to less than 30 p.s.i and then only with effective chip guarding and
personal protective equipment which meets the requirements. The 30 psi
requirement does not apply for concrete form, mill scale and similar cleaning
purposes
Who shall be allowed to operated a powder-actuated tool? - Only employees who
have been trained in the operation of the particular tool in used
All employees using abrasive wheels shall be protected by? - Eye protection
equipment
Guarding, all portable, power-driven circular saws shall be equipped with what? -
Guards above and below the base plate or shoe. The upper guard shall cover the
saw to the depth of the teeth, except for the minimum arc required to permit the
base to be tilted for bevel cuts. The lower guard shall cover the saw to the depth of
the teeth, except for the minimum arc required to allow proper retraction and
contract with the work. When the tool is withdrawn from the work, the lower guard
shall automatically and instantly return to the covering position.
Valve protection caps shall not be used for lifting cylinders from one vertical
position to another. - Bars shall not be used under valves or valve protection caps
to pry cylinders loose when frozen. Warm, not boiling, water shall be used to thaw
cylinder loose
How should compressed air be secured? - In an upright position at all times except,
if necessary, for short periods of time while cylinders are actually being hoisted or
carried
What distance shall Oxygen cylinders in storage be separated from fuel-gas
cylinders or combustible materials (especially oil or grease)? - A minimum
distance of 20 ft (6.1m) or by non-combustible barrier at least 5 ft (1.5m) high
having fire-resistance rating of a least one-half hour. [Show Less]