What is the purpose of the Multi-TDL Network (MTN)? - ANSWER-Satisfy JTF Info. Exchange Requirements (IERs)
What is used to promulgate detailed tasking
... [Show More] and provide instructions regarding the operations of tactical data links? - ANSWER-OPTASK LINK
The mandated standard for the USMTF Messages is the? - ANSWER-MIL STD 6040
The Operational Tasking Data Links (OPTASK LINK) is a directive message from the 1.________ written by the _______ that provides information for the establishment and conduct of data link operations. - ANSWER-1. AADC
2. JICO
A JTIDS/MIDS pulse is _____ wide. - ANSWER-3MHz
The JTIDS/MIDS frequency band is from _____ to _____. - ANSWER-960 to 1215MHz
The packing formats that use 444 pulses are? - ANSWER-P2DP, P4SP
One JTIDS/MIDS pulse carries _____ transmission bits of info? - ANSWER-5 bits
The components of a timeslot are - ANSWER-JITTR, Sync & Header, Data & Propagation
What defines all J series messages - ANSWER-MIL STD 6016
In MIL STD 6015 what provides detailed info on J series messages - ANSWER-Section 5
Precise Participant Location and Identification (PPLI) messages are transmitted in what NPG/s? - ANSWER-NPG 5 & 6
Surveillance information is transmitted in NPG ___ - ANSWER-NPG 7
C2JUs control non-C2JUs by transmitting messages in NPG _____ - ANSWER-NPG 9
Jam resistance is expressed in terms of 1._________ and 2._________? - ANSWER-1. Link Margin
2. Range Ratio
The link margin of JTIDS/MIDS is ____? - ANSWER-21 dB
JTIDS/MIDS uses spread spectrum technology that enables the terminal to frequency hop at about ______________? - ANSWER-76,923 hops/second
How many time slots are in a frame?> - ANSWER-1536
Which access technique uses a common set of timeslots for the same NPG, but is differentiated by operator-selectable net number? - ANSWER-Stacked Nets
During contention access TXs, RXs ________? - ANSWER-Hear the closest TX
There are two types of JTIDS/MIDS connectivity are 1._______ nd 2._______. - ANSWER-1. direct
2. indirect
What are the 3 requirements for direct connectivity? - ANSWER-LOS, S2NR at RX, & good electronic propagation
JTIDS/MIDS transmissions are encrypted by both ______ & ______? - ANSWER-TSEC & MSEC
What section of the NDD specifies each individual platform type's CVLL/SDU assignment? - ANSWER-JANUS Table
Before TXing in JTIDS/MIDS, what 3 requirements must be met? - ANSWER-TX Terminal meets DD1494, FRQ @ TX is assigned, TXs are scheduled & Deconflicted
Before a JTIDS/MIDS network is designed _______ must be defined? - ANSWER-IERs
The two main output products of the Network Design phase are the 1._______ and the 2._______. - ANSWER-1. NDD
2. IDL
For proper timeslot programming, a JITDS/MIDS terminal must be loaded with the correct _______? - ANSWER-IDL
What document would a CJ2U find their assigned find their assigned Track Number Allocation Block? - ANSWER-OPTASK LINK
A JTIDS/MIDS network using a Network Time Reference (NTR) is called a(n)? - ANSWER-System Time Referenced Network (STRN)
A JTIDS/MIDS network using an external time source, such s GPS time is called a(n)? - ANSWER-External Time Referenced Network (ETRN)
The 3 states of sync are...? - ANSWER-Course Sync, Fine Sync, No Sync
________ messages are used to achieve course sync. - ANSWER-IEM - initial entry message
Are multiple NTRs are allowed in a STRN? - ANSWER-NO
Fine sync is achieved after ____ successful RTT interrogations on a course of time quality of 5 or greater? - ANSWER-3
JTIDS/MIDS RELNAV can use the 1.________ coordinate reference system and the 2._______ coordinate reference system. - ANSWER-1. RELNAV
2. RELGRID
The ______ grid is references to WGS-84 latitude, longitude and altitude. - ANSWER-geo
For RELGRID operations, what two things must be assigned? - ANSWER-Nav Controller & Grid Controller
A ________ provides increased positional accuracy for units performing geodetic grid RELNAV - ANSWER-Positional Reference (PR)
During JTIDS/MIDS network operations, ongoing actions to maintain 1.______, 2.______ and 3.______ must be performed. - ANSWER-1. Sync
2. Connectivity
3. IERs
A JTIDS/MIDS network will immediately cease to operate if the NTR of a STRN is lost. T/F? - ANSWER-False
Net number selection, platform indicators and network participation status are part of ____________. - ANSWER-Subscriber Functions
What are the three types of gateways? - ANSWER-Data Forwarders, Routers/Retrans and Translators
The 2 types of data forwarders are? - ANSWER-FRU & FPU
_____________ is required when forwarding Link 16 information to Link 11. - ANSWER-IER based filtering
The _______ is a generic term that describes any net providing voice connectivity from the Area Air Defense Commander (AADC) and units under his command. - ANSWER-ADCCN [Show Less]