EPA - Correct answer-Who administered the clean air act Minimal performance standards - Correct answer-Healthcare regulations and standards provide
... [Show More] consistency of departmental activities by outlining_____ no - Correct answer-are there established emission standards ? false (Joint commission) - Correct answer-The organization that conducts on-site surveys is ISO OSHA - Correct answer-Following standard precaution protocols is required by after cleaning - Correct answer-Instrument lubrications is preformed_____ Antiseptics - Correct answer-These chemicals are used on animate objects to slow the growth of microorganisms Halogens - Correct answer-Iodophors are a member of this disinfectant family clean assembly area before set assembly - Correct answer-electronic testing of laparoscopic insulation should be done at the____ Class II medical device - Correct answer-sterilization packaging is classified as a Canvas - Correct answer-which of the following is not an acceptable sterilization packaging material True - Correct answer-aluminum foil is an acceptable packaging material for dry heat sterilization true - Correct answer-ETO has the longest instrument turnaround time false (alkylation) - Correct answer-ethylene oxide kills by oxidation 64-75 - Correct answer-Temperatures in sterile storage should be door - Correct answer-what is the weakest part of the steam sterilizer the drain - Correct answer-what is the coolest place in the steam sterilizer 270-275 - Correct answer-dynamic air removal sterilizers operate at what temps liquids - Correct answer-Gravity air displacement sterilizers can be used to sterilize ____ lack of contact with steam - Correct answer-the most frequent reason for sterilization failure is 97%-100% - Correct answer-the moisture content of saturated steam should be 2 hours prior to wrapping and sterilization - Correct answer-Lumens should be moistened to allow steam to contact the inner surfaces for how long 10 mins - Correct answer-for a vacuum sterilizer, how long should you leave the door cracked after the cycle is complete 25-30 min - Correct answer-for a gravity sterilizer, how long should you leave the door cracked after the cycle is complete 320 for 2 hours - Correct answer-the most commonly use temperature for dry heat sterilization is true - Correct answer-a control BI should be incubated at least once per day or with each new lot used Class II - Correct answer-Bowie dick test is a class___ prions - Correct answer-CJD is caused by abnormal forms of normal proteins called PEL - Correct answer-indicates the maximum airborne concentration of a contaminate to which an employee may be exposed to over an 8 hour work shift TWA - Correct answer-the employees average exposure in an 8 hour shift of a 40 hour work week alkylation - Correct answer-process by which ETO destroys microorganisms, resulting in the inability of the cell to normally metabolize, reproduce, or both Run,Read,Record, Retain - Correct answer-Process monitoring consist of the four R's 1.0ppm - Correct answer-PEL/TWA limit for ETO 1.0ppm - Correct answer-PEL/TWA limit for hydrogen peroxide( gas plasma) 0.1ppm - Correct answer-PEL/TWA limit for ozone EtO - Correct answer-aeration is only required for which low temperature sterilization method time, temperature, concentration, relative humidity - Correct answer-parameters for ETO 8 hours - Correct answer-minimum recommendations for product aeration at 140 F 12 hours - Correct answer-minimum recommendations for product aeration at 122F Time, temperature, Concentration, Vacuum level, Plasma - Correct answer-Parameters for Hydrogen peroxide Time, Temperature, concentration, Relative Humidity - Correct answer-Parameters for Ozone alkylation - Correct answer-Method of sterilization for Eto oxidation - Correct answer-method of sterilization for hydrogen peroxide oxidation - Correct answer-Method of sterilization for ozone 1-4 hours exposure time plus 8-12 hours aeration - Correct answer-cycle time for ETO 28-50 min - Correct answer-cycle time for hydrogen peroxide 4 hours - Correct answer-cycle time for ozone [Show Less]