The 2 main considerations concerning the existing cabling are? - ANSWER-Grandfathered system
Abandoned cable 11-25
The type of cutover where
... [Show More] cross-connects are relocated one pair after another until completed is called a - ANSWER-rolling cut 11-28
Which practice involves moving the customer to a temporary office space until their section of the retrofit is completed and then moving them back to their recabled office space? - ANSWER-Swing space phasing
Which of these testers would you clamp around a strand of fiber to check for the presence of light? - ANSWER-Fiber strand identifier 11-11
A ______ provides a quick graphical representation of how the circuit is layed out? - ANSWER-CLR 11-27
A ______ uses several pluggable modules to locate and Identify cables. - ANSWER-Office locator kit
A _________ injects light (at a proper wavelength) and measures the results t the other end. - ANSWER-Light source and power meter
A ________ detects the presence of light within a fiber strand - ANSWER-Fiber strand identifier
A _______ uses a laser to identify fiber strands and find breaks in the fiber at the near end. - ANSWER-Visual fault locator
A________ will leave the customer momentarily without communications - ANSWER-Hot-cut 11-28
During a _______, cross-connects are relocated one pair after another until completed. - ANSWER-Rolling cut
*_________ is a property of an electromagnetic field built around a conductor that opposes any changes in current flow in a circuit. - ANSWER-Inductance
____________ is a property of conductors that allows storage of electrical charges when potential differences (voltages) exist between the conductors. - ANSWER-Capacitance
*In AC circuits, the total opposition to current flow is called _________, which is measured in ohms. - ANSWER-Impedance
The nominal characteristic impedance of balanced twisted pair cable is _______ ohms at 100 MHz - ANSWER-100
Pair 626 would be in the __________ Super Binder - ANSWER-Red
Series ______ is the preferred choice for longer runs - ANSWER-11
The _________ connector/s have center pins (choose all that apply) - ANSWER-N
BNC
The way in which others perceive an employee can be divided into 3 distinct areas: body language, Tone of voice and choice of words. Which of the 3 makes the biggest impression? - ANSWER-Body language - 55%
The range of human hearing is from _________ - ANSWER-20 Hz- 20,000 Hz
An increase of _______ will result in a doubling or halving of the power. - ANSWER-3 dB
Increases or decreases of ________ for voltage will cause an increase or decrease of 10 times the original value. - ANSWER-6 dB
The code stands for "flush-or surface-mounted jack" - ANSWER-C
A "push to talk" intercom system would be an example of a ______ transmission method. - ANSWER-half-duplex 1-1
__________ quantifies the bandwidth of a cabling system in a frequency range of interest. - ANSWER-Megahertz
_________ refers to the amount of information that can be transported over the media. - ANSWER-Megabit
A gauge change of ____ numbers approximately doubles or halves the conductors resistance - ANSWER-3
A gauge change of _______numbers approximately doubles or halves the conductors diameter - ANSWER-6
______ is not recommended for new installations (what type of fiber) - ANSWER-OM2
What type of fibers typically support wavelengths of 850 nm and 1300nm - ANSWER-OM1
OM2
OM3
Which fiber is typically loose tube construction and is used outdoors - ANSWER-OS2 (outside plant fiber)
Which fiber/s could I use for a LAN application where the distance between telecommunication spaces is 8,000' - ANSWER-OS1
Modal bandwidth is described in terms of ________ - ANSWER-Megahertz per kilometer
Through the use of _______ optical fiber, the effects of modal dispersion are reduced but not eliminated. - ANSWER-Graded index
The core diameter of OS2 fiber is ______ microns - ANSWER-9
The diameter of the tight buffer of OM3 fiber is ______ microns - ANSWER-900
_______ optical fiber cables are primarily used outdoors. The allow for the cable jacket to expand and contract with changes in temperature without affecting the fibers. - ANSWER-Loose tube
_______ contain multiple 900 micron tight-buffered strands under a single jacket - ANSWER-Distribution
_______ consists of up to 24 strands bundled together in a single line. It uses an array connector (MPO) and can be quickly spliced when using special equipment. - ANSWER-Ribbon
The color code for singlemode optical fiber is ________ - ANSWER-Yellow
The color code for multimode optical fiber with a 50 micron core diameter (laser optimized) is - ANSWER-Aqua
The ______ can terminate from 6 - 72 fibers in a single ferrule - ANSWER-MPO
The consolidation point (CP) should be limited to serving a maximum of ________ equipment outlet spaces - ANSWER-12
The consolidation point (CP) should be at least ______ feet from the TR - ANSWER-50
You should look in ANSI/TIA - ______ if you needed information on the labeling standard. - ANSWER-606 A-38,39 [Show Less]