An informal term for manning requirements not validated by higher headquarters, but
deemed important to the mission by org. leadership. - CORRECT
... [Show More] ANSWER-The term
Out-of-hide means?
Air Force Tactics, Techniques, and Procedures (AFTTP) - CORRECT ANSWER-What
does AFTTP stand for?
Maintenance Concept : Depot-level Maintenance - CORRECT ANSWER-Which
maintenance concept has "maintenance requiring the overhaul, upgrading, or rebuilding
of parts, assemblies, or subassemblies, and the testing and reclamation of equipment
as necessary."? (AFI 21-101) 1.3
MAJCOMs - CORRECT ANSWER-__________ "assigned combat coded fighter aircraft
will coordinate with Mission Design Series (MDS) lead and using commands and the
MAJCOM Operations Directorate (MAJCOM/A3) to develop and document standardized
MDS and Primary Aerospace Vehicle (Aircraft) Authorized (PAA) specific utilization rate
standards in their supplements to this instruction." 21-101 1.3
Flammable vapors - CORRECT ANSWER-What exist at over the surface of JP-4 @ -10
degrees F and above and aviation gasoline @ -50 degrees F and above?
Combat power - CORRECT ANSWER-A trained maintenance unit is key to an effective,
what?
Aircraft Weight Principles - CORRECT ANSWER-1. Basic Weight
2. Operating Weight
3. Zero Fuel Weight
4. Ramp Weight
5. Takeoff Gross Weight
T.O. 1-1B-50 Weight and Balance - CORRECT ANSWER-Which TO provides
information and instructions for maintaining the charts and forms (DD Form 365 series
or electronic equivalent) that provide the means for maintaining continuous record and
control of aircraft weight and balance?
Weight Limits - CORRECT ANSWER-Which term is a combination of performacne,
control, and structural restrictions. Exceeding these limits can result in loss of acft and is
expressly forbidden?
Aircraft Weight - CORRECT ANSWER-Which term is a combination of actual weighing,
accurate record keeping, and proper use of the acft specific manuals, charts, forms, and
loading manuals?
Century of Gravity (CG) - CORRECT ANSWER-Which term is defined by the most
forward and aft permissible CG locations and are called forward and aft CG limits,
respectively.
Balance - CORRECT ANSWER-Is a condition of stability, which exists in a acft when all
weights and forces are acting in such a way as to prevent rotation.
Balance Arm - CORRECT ANSWER-The term at which a number of weights could be
concentrated to produce the same effect as they produced when separated. [Show Less]